How to Choose a DC24V RGB Pixel Wall Washer for Landscape and Facade Lighting
B2B selection guide for a published DC24V RGB aluminium wall washer with 24 W maximum consumption, 12.5 cm pixel pitch, beam options and IP65.
Project image and viewing distance
Buyers should begin with the visual task, viewing distance and mounting geometry, rather than choosing a product from the name alone.
Published configuration
The published configuration is model L-W-10048-DGL-24V: DC24V, SMD5050 RGB diode, IC 2903, 1000 x 32 x 25 mm body, 120 degree beam and 30/60/90/120 degree lens-angle options.
Power and voltage-drop planning
The page lists 24 W maximum consumption. At DC24V, 24 W divided by 24 V equals 1 A per fitting as a maximum-load calculation. For ten fittings, 10 x 24 W = 240 W and 240 W divided by 24 V = 10 A. This is a circuit-planning starting point; divide large runs by the approved drawing and test loaded voltage at each circuit end.
Control architecture
The page lists IC 2903 and a 12.5 cm pixel pitch. Treat these as product-specific control information: confirm final IC, controller compatibility, data direction, pixel grouping and connector pinout. Do not infer controller capacity or assign a universal DMX channel count from these published details.
Installation and protection
The page publishes IP65, CE and RoHS, with an aluminium shell and -20C to 60C working-temperature record. IP65 applies to the specified fitting; cable exits, field joints, drainage, mounting orientation and service clearance remain part of the installed system. Lens angle should be chosen from wall height, set-back distance and required wash width, not from a catalogue image alone.
Quick selection table
| Project condition | Selection guidance |
|---|---|
| Facade wash width | Choose 30/60/90/120 degree lens from wall geometry. |
| Long facade | Use 24 W maximum as a calculation basis and divide circuits. |
| Detailed RGB effect | Assess 12.5 cm pixel pitch against viewing distance. |
| Outdoor exposure | Use published IP65 fitting data and plan every field joint. |
| Visible daytime finish | Review aluminium shell, mounting direction and service access. |
| Control system | Confirm IC 2903, controller, data mapping and connectors. |
Where the configuration fits
LIKELIGHT can be evaluated for landscape walls, building façades and controlled RGB wash where repeated 1 m aluminium fittings, 12.5 cm pixel steps and selectable optical angles fit the design. A narrow lens is not automatically better: it is useful only when the geometry needs a concentrated wash. For close viewing or detailed media content, assess the 12.5 cm pixel pitch against the required visual resolution.
| Model | The published configuration is model L-W-10048-DGL-24V: DC24V, SMD5050 RGB diode, IC 2903, 1000 x 32 x 25 mm body, 120 degree beam and 30/60/90/120 degree lens-angle options. |
|---|---|
| Published configuration | The page lists 24 W maximum consumption |
| Published configuration | The page publishes IP65, CE and RoHS, with an aluminium shell and -20C to 60C working-temperature record |
Information before quotation
Before quotation, send the layout, quantities by zone, viewing distance, target effect, installation environment, controller information, cable direction and sample or delivery requirement. These inputs are used to evaluate the product as part of a complete project system.
