2024-03-27

How to connect the Led strip

How to connect the Led strip

1. Cut the light strip

The cutting method of the lamp strip is that each meter blank of the lamp strip is actually a cutting point. If it is cut elsewhere, it will damage the wiring of this light strip, which will cause the light strip to be damaged.

2. Connector socket

Insert one end of the connector tip into the lamp strip wire, making sure the tip is in contact with the wire, and insert the low end to ensure adequate conduction.

3. Connect the power cable

Align the other end of the lamp strip connector with the pin of the power cord and plug it in. The power cable plug lights up when it is powered on. If the light bar does not light, you can insert the other end of the light bar from the second step.

4. Close the tail plug

Unplug the tail plug of the power cord to ensure the safe use of the circuit.

Related Blogs

20mm Wide COB Strip: Specify Heat, CCT and 30W/m Power Before Installation

A wide COB line can improve luminous coverage, but its 30W/m load, 20mm profile fit, CCT choice and IP20 boundary must be resolved together. This guide turns the published values into a buyer decision.

DMX512 Linear Lights: Budget Universes and DC24V Circuits Separately

A facade can pass its animation test yet fail at scale when DMX channels and power branches are treated as the same limit. This guide calculates both for the LIKELIGHT 8 pixels/m RGB linear light.

SM16703P Sign Modules: Set Letter Depth and Pitch Before Ordering

Module count alone cannot predict an even sign face. This guide uses the published 70×12mm body, DC12V, 0.96W and 20-module string to plan optical mock-ups, power zones and cascade order.