2024-01-25

New Year jewelry LED lights with five installation points

The bell of the New Year is about to ring, and people who have been busy for a year will get together with their loved ones and enjoy the most warm time of the year. In order to set off the festive atmosphere, many families will decorate the house, in addition to the traditional lanterns, firecrackers, pepper shaped decorations, LED lights this year has also become more popular decorations, flashing lights in not only can increase the festive atmosphere, but also can still shine at night, which is different from traditional ornaments.
The LED light belt should also pay attention to safety when in use to prevent dangerous accidents. The following is a small series for everyone to sort out some of the LED light belt installation points.

1, indoor installation

When the LED light belt is used for interior decoration, it is very simple to install because it does not have to withstand wind and rain. The back of the LED light belt is covered with self-adhesive 3M double-sided tape. The sticker on the surface of the 3M double-sided tape can be directly removed during installation, and then the light strip is fixed in the place where it needs to be installed. It is good to press flat by hand. What about places that need corners or are long? Very simple, the LED light belt is a circuit structure composed of 3 leds in a series and parallel way, and every 3 leds can be cut off and used separately.

2, outdoor installation

Outdoor installation because it will be subjected to wind and rain, if 3M glue is used to fix it, over a long time it will cause 3M adhesivities to decrease and lead to LED light strips falling off, so outdoor installation is often fixed by card slot. Where you need to cut and connect, the method is the same as indoor installation, but you need to be equipped with waterproof glue to consolidate the waterproof effect of the connection point.

3. Power connection method

The general voltage of the LED lamp belt is DC 12V, so it is necessary to use a switching power supply, and the size of the power supply is determined according to the power and connection length of the LED lamp belt. If you do not want each LED light strip to be controlled by a power supply, you can buy a relatively large switching power supply as the total power supply, and then connect all the LED light strip input power supply in parallel (if the wire size is not enough, it can be extended), and it is unified by the total switching power supply. The advantage of this is that it can be centrally controlled, and the inconvenient place is that the lighting effect and switch control of a single LED light belt cannot be achieved, and the specific way can be measured by yourself.

4. Controller connection mode

LED lights and RGB full color lights need to use the controller to achieve the changing effect, and the control distance of each controller is not the same, in general, the control distance of the simple controller is 10 to 15 meters, the control distance of the remote control controller is 15 to 20 meters, and the longest can be controlled to 30 meters. If the connection distance of the LED lamp strip is long, and the controller can not control that long lamp strip, then you need to use a power amplifier to tap.

5, pay attention to the connection distance of the LED light belt

In general, the 3528 series of LED light belt has a maximum connection distance of 20 meters, and the 5050 series of LED light belt has a maximum connection distance of 15 meters. If this connection distance is exceeded, the LED light belt is easy to heat, and the service life of the LED light belt will be affected during use. Therefore, when installing must be installed in accordance with the requirements of the manufacturer, do not let the LED light with overload operation.
The above is the installation of the LED light belt, we are in use, the most important thing is to install according to the requirements of the manufacturer, as far as possible to avoid the occurrence of unfortunate events.